A SO2
B H2S
C Radioactive fallout
D Fungal pores
Answer C
2.Which of the following gases vary significantly over time and place at the atmospheric boundary?
A Carbon Dioxide
B Water vapour
C Ozone
D Oxygen
Answer B
3. How does atmospheric pressure vary with increase in altitude?
A Decreases linearly
B Decreases exponentially
C Increases linearly
D Increase till stratosphere and then starts decresing with altitude
Answer B
4. When the reverse lapse rate occur, a dense cold stratum of air at ground level gets covered by lighter warmer air at higher level is known as
A Lapse rate
B Inversion
C Adiabatic lapse rate
D None of above
Answer B
5. Plume behaviour that occurs during warm seasons and clear skies associated with turbulent winds is….
A Coning
B Fanning
C Lofting
D Looping
Answer D
6. Which of the following is bad case of atmospheric condition for dispersion
A Fumigation
B Trapping
C Coning
D Fanning
Answer A
7. Factors Affecting Plume Rise are
A Exit velocity
B Wind Speed
C Lapse Rate
D All of the above
Answer D
8. According to BIS, a minimum stack height is
A 20m
B 40m
C 30m
D 50m
Answer C
9. What is SO2 emission rate if a thermal power plant burns 5.45 tonnes with 4.2% sulphur per hr
A 125.2 gm/sec
B 127.2 gm/sec
C 57gm/sec
D 121.2gm/sec
Answer B
10. Which of the following is secondary pollutant.
A SPM
B PAN
C SO2
D NO2
Answer B
11. When environmental Lapse Rate (ELR) is less is than Adiabatic Lapse Rate (ALR), then which of the following occurs?
A Sub adiabatic lapse rate
B Super adiabatic lapse rate
C Neutral lapse rate
D Adiabatic lapse rate
Answer A
12. Determine effective stack height of stack with following data:
Stack ht-205m , Wind velo-3.56m/s, air temp-13℃, pressure-1000milibars, stack gas velo-9.14m/s, stack gas temp-140℃.
A 211.54m
B 200m
C 300m
D 6.54m
Answer A
13. In Gaussian Equation σy and σz indicates
A Pollutant release rate
B Effective height
C Standard deviations
D Concentration
Answer C
14. Which of the following are not natural sources of pollutant?
A SO2
B H2S
C Radioactive fallout
D Fungal pores
Answer C
15. Estimate stack height for particulate release rate of 875kg/hr.
A 100m
B 106.8m
C 60.3m
D 40m
Answer B
No comments:
Post a Comment